2711 AVENUE L DICKINSON, TX 77539 Get Directions
2711 AVENUE L DICKINSON, TX 77539 Get Directions
Located in Center Point, TX, Brandon CP has a 25 acre facility specializing in Fabrication and Inspection of Fired Heater components such as (but not limited to Radiant, Convection, ducts, stacks, ladders & platforms, Panel and Module Fabrication and Assembly,coil work, SCR units). We are a full service heater fabrication facility offering steel, paint, refractory, and coil work. Brandon CP Steel Work is in accordance AWS D1.1, CWB (Canadian Welding Bureau). Brandon CP utilizes only top notch materials and personnel. (Over 150 years of combined personnel experience in heater fabrication). Brandon CP Coil Work is in accordance with the following ASME section I ("PP" stamp, "U" Stamp, "R" stamp), ASME section VIII, ASME B31.1 and B31.3, We have over 200 weld procedures on file encompassing exotic high alloy materials both wrought and cast developed specifically for fired heaters and furnaces. Brandon CP - Refractory work specializes in the following:
Installation of Single and Dual layer castable liner system (Pour and/or gunned), Installation of Ceramic Fiber Modules, Installation of Ceramic Fiber Blanket, Installation of refractory anchors, Installation of Fiber Board (BTU and TR grade).
© Dun & Bradstreet, Inc. 2025. All rights reserved.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.